Miter Capability The PMI-20 is equipped with turn table that allows the set up of any miter cut in seconds. A positive lock of the table is released and then built in handles allow for easy turning of the saw blade approach. Several positive stops via locking pin allow for rapid and accurate set up of the angle to be cut. The work piece DOES NOT need to be moved from the 90° in feed direction.
5 HP Saw Motor This strong drive system via 5 HP saw motor allows for maximum cutting force and chip removal. This additional power will also extend the life of the saw blade between regrinds.
Upcut Design and Saw Blade Chamber The PMI-20 is an Upcut saw. The saw blade is housed under the work table and travels up through the work piece. This has several advantages such as, safety (less blade exposed during cut), chip removal and longer blade life.
Precision Ground Work Table with Special Surface Coating The work table is a ground surface and is coated with a special Chromate coating. This coating prevents marring the outside of your work piece.
Material Clamping The pneumatic clamping system had adjustable clamping pressure to prevent distortion of thin wall profiles. The top clamp holds the work piece of both sides of the saw blade to deliver a burr free cutoff part. This clamp is controlled by its own cylinder and has adjustment according to the size of the work piece.
Saw Blade Feed The saw blade feed is controlled via a pneumatic cylinder with full control of the feed rate. This will allow for accurate cuts and long blade life. In addition, the saw blade travel is controlled for fastest cycle time.
Precise Micro-Drip Blade Lubrication System The blade if lubricated via a micro-drip system. A small amount of lubricant is introduced to an air line at the point of discharge for control and economical distribution of the saw lubricant.
SAFETY FEATURES
Safety Machine Enclosure The work table in guarded via a machine enclosure that is also monitored by a limit switch. The cover must be close for saw to cycle.
Two Hand Cycle Start Activation Dual start push buttons insures that the operator has both hands free of the machine.
Safety Limit Switch Blade access door is protected via limit switch that will shut down the machine in the case of open door.
Copyright Industry Saw & Machinery Sales. All Rights Reserved.
Information and prices on this website are subject to change without notice. Products and Logos in this website are trademarks or registered trademarks of their respective companies or mark holders.Industry Saw & Machinery Sales - 866-685-7297 - Sales@IndustrySaw.com - 2023
